Give a Gift FREE Book
URL:
https://www.woodsmith.com/article/enlarge-a-hole/
Share Page:

Enlarge a Hole

By: Woodsmith staff
Like most woodworkers, I make the occasional mistake when working on a project. Some are easy enough to fix, while others are more difficult to address. One of the challenges I encountered recently was to increase the size of a hole that was cut 1⁄4" too small. Here's any easy way to do that.

The location of the hole had to be exact and I knew it would be difficult to accurately center the workpiece directly under a larger bit. To solve the problem I turned to my hand-held router and a pair of router bits. I started with a rabbeting bit set to cut 1⁄8" deep. The bottom edge of the hole was used to guide the bearing of the bit as I routed around the entire circumference of the hole.

Then I switched to a pattern bit. With the bearing of the bit held firmly against the newly cut rabbet, I was able to remove the rest of the waste from the hole (right drawings). The end result was a perfectly centered hole that’s just the right size.

Published: Sept. 13, 2018
Share Page:
Topics: None

Product Recommendations

Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.

SHN_5FreePlans_300x250

WSM Sidebar Ad_PlywoodProjectsSIB

Newsletter Articles